Tile Calculator

Enter the area, the tile size, the grout joint and how many tiles come in a box, and get the whole tiles and boxes to buy, with a waste allowance you can change, rounded up once.

Estimates for planning, not professional advice. Read the full notice.

Area and tile

Like 11 m²

reads as 20 square metres, 215.28 square feet

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 600 millimetres, 1 foot 11 and 5 eighths inches

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 300 millimetres, 11 and 13 sixteenths inches

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 3 millimetres, 1 eighth of an inch

Example: a tiled floor

16 boxes of tiles

  • Tiles to cover the area 109.46 tiles
  • Tiles with the waste allowance 121 tiles
  • Tiles left in the last box 7 tiles

Estimate for planning, from what you entered and the product data shown. Check product labels and your supplier before you buy.

  • Tiles (boxes) 16

Share this project

This link carries:

    The project is inside the link, after the # sign. Browsers do not send that part to the site.

    Questions

    How many extra tiles should I allow for?

    The waste allowance starts at a typical figure and you can change it. No standard sets one number, so use the allowance your layout, your tile and your supplier point to.

    Does the grout joint change the number of tiles?

    Yes, a little for large tiles and more for small ones. Each tile takes its own size plus the joint, so a wider joint means fewer tiles for the same area. The calculator uses the joint you type, and none if you leave it empty.

    How many boxes do I need?

    The calculator rounds the tiles up once, then divides by the tiles in a box and rounds up once more to whole boxes. The tiles per box are on your own tile label; the list holds only common counts.

    Worked example: a tiled floor

    Show the working
    1. Area one tile takes, joint included 603 mm (1 ft 11 3/4 in) × 303 mm (11 15/16 in) = 0.1827 m² (1.9667 ft²)
    2. Tiles to cover the area 20 m² (215.28 ft²) ÷ 0.1827 m² (1.9667 ft²) = 109.46 tiles
    3. Add the waste allowance, once 109.46 tiles × 1.1 = 120.41 tiles
    4. Round up once, to whole tiles 120.41 tiles = 121 tiles
    5. Boxes: divide by the tiles in a box, round up once 121 tiles ÷ 8 = 16 boxes of tiles

    Assumptions

    The figures behind the example. Sourced figures link to their source below; a default is a starting value to check against your label or supplier.

    AssumptionValueDetails and changes
    Tile waste allowance 10%
    Default A typical allowance, not a figure from a standard. Change it to the allowance you want; check your tile label or supplier.
    Grout joint width 3 mm (1/8 in, converted)
    Default Your own joint width: check the spacing on your tile label or with your supplier.
    Tiles per box 8 tiles
    Default The tiles per box are on your tile label or your supplier's sheet; the list offers common counts.