Concrete Mix Ratio

A concrete mix ratio gives the parts of cement, sand and coarse aggregate by volume, measured in the same bucket; this page shows the water each maker prints for one bag of ready-blended mix. No ratio is shown: the mix table of Holcim's General Purpose Cement sheet is a graphic whose wording could not be confirmed, so its parts are left out.

Estimates for planning, not professional advice. Read the full notice.

Work it out for your own sizes

Concrete Bag Calculator

Example to try: Length 2.4 m (7 ft 10 1/2 in), Width 1.8 m (5 ft 10 7/8 in), Depth 100 mm (3 15/16 in)

Water for one bag of ready-blended mix

The water each maker's sheet gives for one bag of its blended concrete or mortar

The water each maker's sheet gives for one bag of its blended concrete or mortar
ProductBag sizeWater per bag
Blue Circle Multi-Purpose Concrete 20 kg (44.09 lb)2 L (per Blue Circle's data sheet, checked 12 Nov 2026)
Blue Circle High Strength Concrete (40N) 20 kg (44.09 lb)2 L (per Blue Circle's data sheet, checked 12 Nov 2026)
Holcim High Performance Concrete, first figure of its range 20 kg (44.09 lb)approx. 2 L (per Holcim's data sheet, checked 12 Nov 2026)
Holcim High Performance Concrete, second figure of its range 20 kg (44.09 lb)2.8 L (per Holcim's data sheet, checked 12 Nov 2026)
Blue Circle Quality Assured Mortar (mortar, not concrete) 20 kg (44.09 lb)4 L (per Blue Circle's data sheet, checked 12 Nov 2026)

Product names are trademarks of their owners. HoneyDoMath is not affiliated with, sponsored by or endorsed by these makers. Figures come from each maker's published sheets and are shown for information only.

Sources: [1][2][3][4]

A bag of blended mix needs no cement or ballast of your own: only the water. Holcim gives a range, so its two figures have a row each.

Mixing by hand

Where a bag of mix is not used, the parts of the ratio are measured out in the same container. Blue Circle's sheet for a bagged mix says this about mixing by hand, and Holcim's about the water:

If mixing by hand, mix on a clean board and take care to avoid loss of water and cement during mixing.

Tarmac Trading Limited (Blue Circle), Multi-Purpose Concrete Product Data Sheet (December 2023)[1]

Too much water reduces the strength, durability and bond and can cause cracking.

Holcim UK, 40N High Performance Concrete technical data sheet (April 2025)[3]

Why a ratio is a starting point

A ratio sets the parts, not the finished concrete. Blue Circle's cement sheet says this about settling the proportions:

Trial mixes are recommended to determine the optimum mix proportions.

Tarmac Trading Limited (Blue Circle), General Purpose Cement Product Data Sheet (December 2023)[5]

For the amount to mix, work the base out in cubic metres first, on the bag calculator page or the cement and concrete page.

Questions

What is the ratio of ballast to cement for concrete?

Holcim's cement sheet prints its mixes by volume in a graphic whose wording could not be confirmed, so no ratio is shown on this page.

How do I mix concrete by hand?

Measure the parts in the same container and mix them on a clean board, taking care not to lose water or cement while mixing. A bag's sheet gives its own water.

How much water does a bag of concrete mix need?

Each maker prints its own figure for its own bag. The table on this page gives the water for four products.

Calculate it for your project

Enter your own sizes to get the amount to buy or the layout figures, with the maths shown and a page to print.

Concrete Bag Calculator

Sources (5)

  1. Multi-Purpose Concrete Product Data Sheet (opens in new tab), Tarmac Trading Limited (Blue Circle), December 2023. Manufacturer data.
    “If mixing by hand, mix on a clean board and take care to avoid loss of water and cement during mixing.”
    “This can normally be achieved by the addition of 2 litres of clean water per 20kg bag of concrete.”
    Per Blue Circle's data sheet, checked 12 Nov 2026. Figures and regulations change; verify with the source. Back to where this is used (Source 1)
  2. High Strength Concrete (40N) Product Data Sheet (opens in new tab), Tarmac Trading Limited (Blue Circle), December 2023. Manufacturer data.
    “This can normally be achieved by the addition of 2 litres of clean water per bag of concrete.”
    Per Blue Circle's data sheet, checked 12 Nov 2026. Figures and regulations change; verify with the source. Back to where this is used (Source 2)
  3. 40N High Performance Concrete technical data sheet (opens in new tab), Holcim UK, April 2025. Manufacturer data.
    “Too much water reduces the strength, durability and bond and can cause cracking.”
    “Mix the contents with approximately 2 to 2.8 litres of clean water.”
    Per Holcim's data sheet, checked 12 Nov 2026. Figures and regulations change; verify with the source. Back to where this is used (Source 3)
  4. Quality Assured Mortar Product Data Sheet (opens in new tab), Tarmac Trading Limited (Blue Circle), December 2023. Manufacturer data.
    “This can be normally obtained by the addition of 4 litres of water per 20 kg bag”
    Per Blue Circle's data sheet, checked 12 Nov 2026. Figures and regulations change; verify with the source. Back to where this is used (Source 4)
  5. General Purpose Cement Product Data Sheet (opens in new tab), Tarmac Trading Limited (Blue Circle), December 2023. Manufacturer data.
    “Trial mixes are recommended to determine the optimum mix proportions.”
    Per Blue Circle's data sheet, checked 12 Nov 2026. Figures and regulations change; verify with the source. Back to where this is used (Source 5)

These are summaries of what the sources say, not professional advice. Rules and product data change. Check with your local building control office and the product label about your own project.