How to Measure Roof Pitch

To measure roof pitch, hold a spirit level against a rafter, measure the gap to the rafter at the far end and turn that rise over the run into an angle: a rise of 400 mm (1 ft 3 3/4 in) over a run of 1 m (3 ft 3 3/8 in) is 21.8 degrees.

Estimates for planning, not professional advice. Read the full notice.

Work it out for your own sizes

See a rise and a run turned into degrees

Example to try: Rise 400 mm (1 ft 3 3/4 in), Run 1 m (3 ft 3 3/8 in)

Step by step

  1. Step 1: Hold a spirit level against a rafter

    From the loft, set a spirit level against the underside of a rafter and move it until the bubble sits in the centre. The length of the spirit level along the rafter's line is the run, here 1 m (3 ft 3 3/8 in).

  2. Step 2: Measure the rise with a tape

    Measure straight up or down from the end of the spirit level to the rafter. That gap is the rise; here it is 400 mm (1 ft 3 3/4 in).

  3. Step 3: Turn the rise and the run into degrees

    Divide the rise by the run to get the slope as a fraction, then find the angle whose tangent is that fraction. 400 mm (1 ft 3 3/4 in) over 1 m (3 ft 3 3/8 in) is a slope of 40 per cent, which is 21.8 degrees.

  4. Step 4: Or read the angle from an angle finder

    A digital level or angle finder laid along the rafter shows the angle in degrees without any sums. The table below lets you check a reading against a measured rise.

From a measured rise to degrees

Roof pitch in degrees and as a percentage for each measured rise over the same level run

Roof pitch in degrees and as a percentage for each measured rise over the same level run
Rise over a level run of 1 mDegreesSlope (%)
100 mm 5.71 degrees10 per cent
200 mm 11.31 degrees20 per cent
300 mm 16.7 degrees30 per cent
400 mm 21.8 degrees40 per cent
500 mm 26.57 degrees50 per cent
600 mm 30.96 degrees60 per cent
800 mm 38.66 degrees80 per cent

Estimate for planning, from what you entered and the product data shown. Check product labels and your supplier before you buy.

Each row is worked out from its own rise and the same run. A longer or shorter spirit level gives the same angle for the same slope.

Questions

How do I work out roof pitch?

Divide the rise by the run, then find the angle whose tangent is that fraction. The table on this page does it for a run of one metre.

How do I measure roof pitch from the loft?

Hold a spirit level against the underside of a rafter, centre the bubble and measure the gap to the rafter at the far end of the spirit level. That gap is the rise and the spirit level's length is the run.

Is a roof pitch given in degrees or per cent?

Both are used. Degrees measure the angle of the slope and per cent is the rise as a share of the run; the table shows the two side by side.

Calculate it for your project

Enter your own sizes to get the amount to buy or the layout figures, with the maths shown and a page to print.

See the pitch working again