Tile Layout Calculator
HoneyDoMath.eu
Enter the length and width, the tile and the joint, pick where to start, and get the tiles and boxes for a straight layout with the cut tiles counted. Running bond and herringbone layouts are not covered.
Estimates for planning, not professional advice. Read the full notice.
Example: a tiled floor laid from a wall
20 boxes of tiles
- Whole tiles along the length 14 tiles
- Cut tile at the end of the length 258 mm (10 3/16 in)
- Whole tiles along the width 11 tiles
- Cut tile at the end of the width 267 mm (10 1/2 in)
- Tiles with every cut from its own tile and the waste allowance 198 tiles
Estimate for planning, from what you entered and the product data shown. Check product labels and your supplier before you buy.
Result
Enter a size to see your total.
Each product is rounded up once for the whole project, so the total can be less than the items bought alone added together. A line counted from a cut layout (sheets, boards or tiles laid out piece by piece) is counted for each item and added.
- Tiles (boxes) 20
Questions
Where does the first tile go?
The calculator counts the tiles for the start you pick: from a wall, centred on a tile or centred on a joint. A centred start puts a cut tile on both walls; which start suits your room is your decision.
Is a thin cut tile a problem?
The page shows the cut width at the end of each line so you can compare the starts. Whether a narrow cut is acceptable depends on your tile and your tiler.
Worked example: a tiled floor laid from a wall
Show the working
- Tile and joint: the pitch along each line 300 mm (11 13/16 in) + 3 mm (1/8 in) = 303 mm (11 15/16 in)
- Whole tiles along the length, rounded down 4.5 m (14 ft 9 3/16 in) ÷ 303 mm (11 15/16 in) = 14 tiles
- Whole tiles along the width, rounded down 3.6 m (11 ft 9 3/4 in) ÷ 303 mm (11 15/16 in) = 11 tiles
- Tiles across the grid, a cut tile counted as a tile 15 tiles × 12 tiles = 180 tiles
- Add the waste allowance once, round up, then count boxes 198 tiles ÷ 10 = 20 boxes of tiles
Assumptions
The figures behind the example. Sourced figures link to their source below; a default is a starting value to check against your label or supplier.
| Assumption | Value | Details and changes |
|---|---|---|
| Tile waste allowance | 10% | |
| Default A typical allowance, not a figure from a standard. Change it to the allowance you want; check your tile label or supplier. | ||
| Grout joint width | 3 mm (1/8 in, converted) | |
| Default Your own joint width: check the spacing on your tile label or with your supplier. | ||
| Tiles per box | 10 tiles | |
| Default The tiles per box are on your tile label or your supplier's sheet; the list offers common counts. | ||
Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm