Tile Adhesive Calculator

Enter the area and pick the rate printed on your own bag of adhesive, then the bag size, and get the kilograms and the bags to buy, rounded up once. The rates and bag sizes are example values, not a maker's range.

Estimates for planning, not professional advice. Read the full notice.

Area and adhesive

Like 11 m²

reads as 20 square metres, 215.28 square feet

Example: a tiled floor

4 20 kg (44.1 lb) bags

  • Adhesive for the area 80 kg (176.37 lb)

Estimate for planning, from what you entered and the product data shown. Check product labels and your supplier before you buy.

  • Tile adhesive, 20 kg bag, 20 kg (44.1 lb) bag 4

Share this project

This link carries:

    The project is inside the link, after the # sign. Browsers do not send that part to the site.

    Questions

    Where do I find the rate?

    It is on the adhesive's bag or data sheet, as a weight for each square metre, and it changes with the trowel notch and the tile. Pick the nearest value in the list or compare two rates side by side.

    Why one rate and not a range?

    This page counts the rate you pick, so the bags follow that figure exactly. If your label prints a range, try both ends to compare the smaller and larger counts.

    Worked example: a tiled floor

    Show the working
    1. Adhesive: the area times the rate 20 m² (215.28 ft²) ÷ 1 m² (10.76 ft²) × 4 kg (8.82 lb) = 80 kg (176.37 lb)
    2. Bags: divide by the bag and round up once 80 kg (176.37 lb) ÷ 20 kg (44.09 lb) = 4 × 20 kg (44.1 lb) bags

    Assumptions

    The figures behind the example. Sourced figures link to their source below; a default is a starting value to check against your label or supplier.

    AssumptionValueDetails and changes
    Adhesive rate (example) 4 kg/m²
    Default An example set of rates, not a maker's figure. The rate depends on the tile, the trowel and the adhesive: use the value on your bag.
    Bag size 20 kg (44.1 lb, converted)[1]
    Ardex's data sheet says a 20 kg bag of ARDEX X 77 yields about 19 litres of mortar, at about 1.05 kg of powder per m² per mm of adhesive bed.

    Sources (1)

    1. ARDEX X 77 technical data sheet (opens in new tab), Ardex UK, Data sheet, no date printed. Manufacturer data.
      “A 20kg bag of ARDEX X 77 or ARDEX X 77 W will yield approximately 19 litres of mortar, using approximately 1.05kg of powder per m2 per mm thickness of adhesive bed.”
      “20kg bag ... will cover up to 8m2”
      Per ARDEX's data sheet, checked 14 Nov 2026. Figures and regulations change; verify with the source. Back to where this is used (Source 1)

    These are summaries of what the sources say, not professional advice. Rules and product data change. Check with your local building control office and the product label about your own project.