Board and Batten Calculator

Enter a wall's width and height and the batten width, choose a set number of battens, a largest gap or a board width, and get every batten mark measured from the wall's left edge, with the stock pieces to buy.

Estimates for planning, not professional advice. Read the full notice.

Wall and battens

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 2.4 metres, 7 feet 10 and 1 half inches

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 2.4 metres, 7 feet 10 and 1 half inches

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 40 millimetres, 1 and 9 sixteenths inches

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 2.4 metres, 7 feet 10 and 1 half inches

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

Example: a wall with five battens

5 lengths of batten

  • Gap between battens and at the ends 0.367 m (1.203 ft)
  • Centre to centre 0.407 m (1.334 ft)

Estimate for planning, from what you entered and the product data shown. Check product labels and your supplier before you buy.

  • Batten stock pieces, batten pieces, 40 mm × 2.4 m 5

Share this project

This link carries:

    The project is inside the link, after the # sign. Browsers do not send that part to the site.

    Questions

    What spacing do I use for board and batten?

    Take the batten widths off the wall and share what is left equally between the gaps. With a gap at each end there is one more gap than there are battens.

    How many battens do I need?

    Choose a set number, or give a largest gap or a board width and the calculator finds the fewest battens that keep every gap within it. Each batten is as long as the wall is high, less any rail.

    Worked example: a wall with five battens

    Show the working
    1. Width the battens take 5 battens × 40 mm (1 9/16 in) = 200 mm (7 7/8 in)
    2. Wall left for gaps 2.4 m (7 ft 10 1/2 in) − 200 mm (7 7/8 in) = 2.2 m (7 ft 2 5/8 in)
    3. Gaps: one more than the battens, so the wall ends in a gap 2.2 m (7 ft 2 5/8 in) ÷ 6 gaps = 0.367 m (1.203 ft)
    4. Pieces: each batten is as long as the wall is high, cut from one stock piece 5 battens = 5 lengths of batten

    Assumptions

    The figures behind the example. Sourced figures link to their source below; a default is a starting value to check against your label or supplier.

    AssumptionValueDetails and changes
    Batten width 40 mm (1 9/16 in, converted)
    Default An example value, not a maker's figure. Check the maker's sheet or your supplier and type your own.
    Stock piece length 2,400 mm (7 ft 10 1/2 in, converted)
    Default An example value, not a maker's figure. Check the maker's sheet or your supplier and type your own.