Shiplap Cladding Calculator

Enter a wall's width and height, the exposed width of your boards and their length to get the boards for the wall, counted by rows and by area, rounded up once.

Estimates for planning, not professional advice. Read the full notice.

Wall and boards

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 3.6 metres, 11 feet 9 and 3 quarters inches

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 2.4 metres, 7 feet 10 and 1 half inches

Like 11 m²

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 120 millimetres, 4 and 3 quarters inches

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 3.6 metres, 11 feet 9 and 3 quarters inches

Example: a feature wall

22 boards

  • Rows up the wall 20 rows
  • Boards counted by rows, with waste 22 boards
  • Boards counted by area, with waste 22 boards

Estimate for planning, from what you entered and the product data shown. Check product labels and your supplier before you buy.

  • Shiplap boards 22

Share this project

This link carries:

    The project is inside the link, after the # sign. Browsers do not send that part to the site.

    Questions

    How many shiplap boards do I need for a wall?

    Enter the wall's width and height, the exposed width and the length of your boards. The calculator counts the rows up the wall, cuts each row from boards of your length, adds your waste allowance once and rounds up once. It also counts by area and gives the larger of the two.

    Is the exposed width the same as the face width of the board?

    No. The exposed width is the part that shows once the boards overlap, so it is narrower than the board's full width. Use the exposed width from your own boards.

    What if a row is longer than one board?

    The row is cut from several boards with butt joints and no overlap, and the calculator counts the boards needed for the joined row.

    Worked example: a feature wall

    Show the working
    1. Rows: the wall height over the exposed width, rounded up 2.4 m (7 ft 10 1/2 in) ÷ 120 mm (4 3/4 in) = 20 rows
    2. Boards for the rows: one board of this length spans the wall 20 rows × 1 board = 20 boards
    3. Add the waste allowance, once, and round up once 20 boards + 10% = 22 boards

    Assumptions

    The figures behind the example. Sourced figures link to their source below; a default is a starting value to check against your label or supplier.

    AssumptionValueDetails and changes
    Waste allowance 10%
    Default An example allowance for cuts and breakage, added once. Change it for your own job.
    Exposed width of a board No default
    Default Type it in the field above the result. Check your label or supplier.
    Length of a board No default
    Default Type it in the field above the result. Check your label or supplier.