Featheredge Fence Calculator

Enter the length of the run and the width of your boards, and get how many boards it takes for a spaced, close-boarded or overlapping style; the working shows the real gap between them. Featheredge boards overlap, so enter how far each covers its neighbour.

A ready-made setup of the Fence Calculator.

Estimates for planning, not professional advice. Read the full notice.

Boards

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 20 metres, 65 feet 7 and 3 eighths inches

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 100 millimetres, 3 and 15 sixteenths inches

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 10 millimetres, 3 eighths of an inch

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

Example: a run of boarded fence

182 boards

  • Real gap between boards 0.01 m (0.032 ft)
  • Boards if the first and last sit flush to the end posts 182

Estimate for planning, from what you entered and the product data shown. Check product labels and your supplier before you buy.

  • Fence boards, 100 mm wide 182

Share this project

This link carries:

    The project is inside the link, after the # sign. Browsers do not send that part to the site.

    Questions

    How many featheredge boards do I need?

    Choose the overlapping style and type how far each board covers its neighbour. The count is the run less one overlap, over a board less one overlap, rounded up.

    How many boards are in one section?

    The table gives the boards in a section between posts, for three board widths, with a gap at both posts.

    Worked example: a run of boarded fence

    Show the working
    1. Boards: the run less one gap, over a board plus a gap, rounded up 20 m (65 ft 7 3/8 in) − 10 mm (3/8 in) ÷ 110 mm (4 5/16 in) = 182 boards
    2. Real gap: what is left of the run, shared by the gaps 20 m (65 ft 7 3/8 in) − 182 boards × 100 mm (3 15/16 in) = 1.8 m (5 ft 10 7/8 in)

    Assumptions

    The figures behind the example. Sourced figures link to their source below; a default is a starting value to check against your label or supplier.

    AssumptionValueDetails and changes
    Waste allowance 0%
    Default Your own allowance, added once to the total. Check your label or supplier.

    Boards in one section, by board width

    Boards in one section between posts, with a gap at both posts, at the gap in the example, by section length and board width

    Boards in one section between posts, with a gap at both posts, at the gap in the example, by section length and board width
    SectionBoards of 75 mmBoards of 100 mmBoards of 150 mm
    1.8 m 221712
    2.4 m 292215

    The gap is the largest gap you typed; more boards give a smaller real gap. The widths are examples; use the width of the boards you buy.