Metal Roof Sheet Calculator
HoneyDoMath.eu
Enter the eaves length, the run of a plane, the pitch in degrees, the sheet cover width and the stock length and get the metal roof sheets by column and cut length for a gable or mono-pitch roof, with ridge and trim pieces, each rounded up once. A hip roof is not counted.
Estimates for planning, not professional advice. Read the full notice.
Example: a gable roof in metal sheets
22 metal roof sheets
- Columns on each plane 11 columns
- Cut length of one sheet 4.719 m (15 ft 5 3/4 in)
- Ridge pieces 4 ridge pieces
Estimate for planning, from what you entered and the product data shown. Check product labels and your supplier before you buy.
Result
Enter a size to see your total.
Each product is rounded up once for the whole project, so the total can be less than the items bought alone added together. A line counted from a cut layout (sheets, boards or tiles laid out piece by piece) is counted for each item and added.
- Metal roof sheets, 1 m cover, 6 m long 22
- Ridge pieces, 3 m 4
- Eaves trim pieces, 3 m 7
- Verge trim pieces, 3 m 7
Questions
How many metal roof sheets do I need?
The calculator counts columns across each plane from the eaves length and the cover width, finds the cut length of a sheet from the run and the pitch, and cuts each column from stock. It counts by column and length, never by area.
How long is a metal roof sheet?
The run times the pitch multiplier, plus the eaves overhang measured along the slope.
Worked example: a gable roof in metal sheets
Show the working
- Columns: the eaves length plus the verge overhang at both ends, over the cover width, rounded up 10.1 m (33 ft 1 5/8 in) ÷ 1 m (3 ft 3 3/8 in) = 11 columns
- Cut length: the run times the pitch multiplier, plus the eaves overhang 4 m (13 ft 1 1/2 in) × 1.1547 + 100 mm (3 15/16 in) = 4.719 m (15 ft 5 3/4 in)
- Sheets: the columns on each plane, cut from stock, times the planes 11 columns × 2 planes = 22 metal roof sheets
Assumptions
The figures behind the example. Sourced figures link to their source below; a default is a starting value to check against your label or supplier.
| Assumption | Value | Details and changes |
|---|
Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm